IEC 62300 pdf download

IEC 62300 pdf download

IEC 62300 pdf download Consumer audio/video equipment digital interface with plastic optical fibre
1 Scope
This International Standard specifies the principal electrical and optical parameters for a consumer audio/video equipment digital interface that uses plastic optical fibre (POF).
NOTE A description of the principal features of such an interface is given in Annex C.
2 Normative references
The following referenced documents are indispensable for the application of this document.
For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
IEC 60050-731 , International Electrotechnical Vocabulary (IEV) – Chapter 731: Optical fibre communication
IEC 60793-2-40, Optical fibres – Part 2-40: Product specifications – Sectional specification for category A4 multimode fibres
IEC 60825-1 , Safety of laser products – Part 1: Equipment classification, requirements and user’s guide
IEC 60825-2, Safety of laser products – Part 2: Safety of optical fibre communication systems
IEC 61 754-21 , Fibre optic connector interfaces – Part 21: Type SMI connector family for plastic optical fibre 1
3 Terms, definitions and abbreviations
3.1 Terms and definitions
For the purposes of this document, the terms and definitions contained in IEC 60050-731 apply.
3.2 Abbreviations
BER Bit error rate
D-VCR Digital video cassette recorder
E/O Electrical to optical
HDTV High definition television
O/E Optical to electrical
PECL Positive shifted emitter coupled logic
PMD Physical media dependent
POF Plastic optical fibre
RMS Root mean square
Rx Receiver
SFF Small form factor
STB Set top box
Tx Transmitter
4 System consideration
4.1 Area of application
This digital interface covers audio and/or video and accompanied data systems for consumer audio/video equipment and multimedia systems in bi-direction, mainly used for audio equipment, TV-set, D-VCR, etc.
4.2 Operating environment The environmental conditions for the digital interface are mainly defined in other standards for the individual units. Where no range is given, the interface shall operate at least within the temperature range 0 °C to 50 °C and in a relative humidity range of 25 % to 75 %.
5 Configuration of digital interface and characteristics to be specified
5.1 Configuration of digital interface The basic configuration of this digital interface is shown in Figure 1 . The reference points 1 and 4 apply to the electrical input and output of the electro-optical and opto-electrical converter respectively. The optical matching values specified in this standard apply at the reference points 2 and 3. The overall characteristics of a POF are specified in Annex A for a wide-band POF and in Annex B for the optical connectors.
5.2 Characteristics of electrical interface
The characteristics of electrical interface at the reference points 1 and 4 shown in Figure 1 shall be as specified in Table 1 .

The previous

IEC 62274 pdf download

The next

IEC 62323 pdf download

Related Standards